![]() ![]() Usually, a 10-15 second interval between checks is sufficient.ģ. In the 'PersistentKeepalive' field, specify the frequency of the attempts to verify the availability of the connection's remote side. In the 'Endpoint' field, enter the public IP address or domain name of the WireGuard server and the listening port on which the WireGuard client will set the connection. In the 'Allowed IPs' field, enter the allowed IP addresses in IP/bitmask format - 172.16.82.1/32 (internal server address) and 192.168.22.0/24 (local segment address of the Keenetic router). In the 'PublicKey' field, insert the public key of the server, which can be copied to the clipboard from WireGuard settings in the web interface of the router: NOTE: Important! If you have set up Internet access via WireGuard VPN, in the '' section, you need to specify the DNS server in the 'DNS=' field. It is possible to use a different subnet, choosing it from the private address range and avoiding overlapping with other subnets configured on these devices. Set the IP address in the 'Address' field of the WireGuard client in IP/bitmask format - 172.16.82.10/24 (internal tunnel address). The 'PrivateKey' field of the interface contains the macOS WireGuard client key generated by the program. Opposite to 'On-Demand', select the network interface for the WireGuard client to work through. In the 'Name' field, enter the connection name 'wg-client' (you can specify another name). ![]() NOTE: Important! Leave this window open, do not close it. A connection setup window will open where you need to enter the WireGuard client settings for macOS and the remote WireGuard server Keenetic. Launch the program and click on the down arrow in the lower-left corner. To connect to the Keenetic WireGuard server on a macOS-based computer, you need to download and install WireGuard.ġ. Then move on to the VPN client setup.īelow is an example of connecting to a server from a macOS operating system, using the version macOS Catalina as a reference. The following instruction shows the process : ' Configuring a WireGuard VPN between two Keenetic routers'. If any of these conditions are not met, connecting to such a server from the Internet will be impossible.įirst, you need to configure the WireGuard server on the Keenetic device. ![]() NOTE: Important! If you want to configure a Keenetic router as a VPN server, make sure that it has a public IP address and, when using the KeenDNS service, that it works in the 'Direct access' mode. Starting from KeeneticOS version 3.3, you can use WireGuard VPN to connect to the local network of the Keenetic router remotely. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |